S našimi cookies Vám chceme nabídnout co nejlepší nákupní zážitek se vším, co s tím souvisí. To zahrnuje například vhodné nabídky a zapamatování preferencí. Pokud je to v pořádku, jednoduše klikněte na „Souhlasím“, že souhlasíte s používáním cookies pro preference, statistiky a marketing (zobrazit vše). Svůj souhlas můžete kdykoli odvolat prostřednictvím nastavení souborů cookie (zde).
Musíte být přihlášeni, pokud chcete hodnotit produkty.
Upozornění: Abychom zabránili tomu, že se budou hodnocení zakládat informacích z doslechu, polovičních pravdách nebo skryté reklamě, dovolujeme na našich stránkách hodnotit pouze skutečným uživatelům, kteří u nás vybavení také koupili.
Po přihlášení najdete také v zákaznickém centru v sekci "Hodnotit produkty" všechny produkty, které můžete hodnotit.
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
m
Fingerboard Damager not Saver
mjmorrell 07.01.2018
Bought these to protect my fingerboard whilst doing fretwork.
Unfortunately these had the opposite to the desired affect to saving the fingerboard. The metal savers have burrs on the edge and so they cause fine cuts into the fingerboard of my expensive PRS guitar. I then had to sand these out. After noticing this after doing a few frets I stopped using them and went back to using masking tape.
I would advise not using these at all as they may damage your guitar as they did to mine. I would like to know if Thomann or Warwick are going to compensate for the damaged guitar?
Overall not impressed at all, they don't even deserve 1 star since they actually damaged my guitar which I then needed to repair. Waste of money and worse than if they were just useless.
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
D
Not that great
DT1980 30.03.2020
I bought these to protect the fingerboard during the polishing of the frets. But these things are so sharp that you have more chance damaging the fretboard than without them. Not practical in use either, a real hassle to put them on the board.
Tried them a few times, but never use them anymore.
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
EM
I think these will mark your fretboard
Eugene M. 13.01.2023
I normally mask off the fretboard and use fret rubbers and very fine sandpaper to do frets. I got these as I reckoned they would be faster. They would be I suppose but after doing a few frets on a guitar I began to notice very small little cuts in the fretboard where these 'savers' had been applied for fret cleaning/polishing. So, I stopped using them and went back to my old but slower method. I am a guitar tech and do a lot of guitars and feel these might be ok to use on a cheapo guitar you have modded to go out gigging with but in all honesty, I will not be using them on a mid or expensive level guitar again. The slower and older way is better and will never leave marks.