K&M 40900

It does what you expect, with K&M durability.

Assembly was simple, but I needed to apply more force than I'm comfortable with. Now that it's set up, though, I expect to bequeath it to somebody in my will.

Cage-nuts are supplied and work nicely. If you're not experienced with them expect to lose some skin and swear a lot the first few times you use them. Needle-nosed pliers can help. However, once they're installed, you can balance a rackmount device with one hand while twirling screws with the other, so overall they make life much easier.

As others have noted, there's a ninth set of mounting holes, so if you have a shallow device, you can mount it right at the bottom and get that extra bit of value from the rack.

Bought this to place my Behringer 2600 better on table.
It is very high quality and stable like most of the K&M products.
2600 synth fits very well on it and i highly recommend it.

Only thing to point out that the feet are longer than they seem on the photo and it take a quite a lot of room on the table. I am sure the long feet are very important feature for deeper rackmountable products, but for 2600 they seemed too long. So i needed to cut them to smaller size to fit 2600 better. Now 2600 take half of the space on table. Angle is also very good and comfortable to use.