A
Decent light stand for the price
I bought 2 of these, and all in all they are pretty decent. It's nice that they are supplied with 4 bolts and wing-nuts to affix lights (although you will need big washers if your lights have large fixture holes in)
My only one gripe is they could be a little wider to allow better spacing of my lights. I find getting 4 lights on there is easier said that done. 2 x-Bricks, 1 scanner and 1 laser. I ended up mounting the X-bricks on top and the scanner and laser underneath them so only using 2 mounting holes, not the 4.
They would be perfect for PARS and smaller lights and bigger ones with a little creativity :)
Overall though, very happy with the stability and for what they cost no complaints here.
My only one gripe is they could be a little wider to allow better spacing of my lights. I find getting 4 lights on there is easier said that done. 2 x-Bricks, 1 scanner and 1 laser. I ended up mounting the X-bricks on top and the scanner and laser underneath them so only using 2 mounting holes, not the 4.
They would be perfect for PARS and smaller lights and bigger ones with a little creativity :)
Overall though, very happy with the stability and for what they cost no complaints here.
0
0
Report
BL
Lightweight stand
Good strength, stability och quality. Also easy and fast to setup. Some details in plastic but they seem to be OK. Only one major issue, but its an importnant one to consider! The width btw the mounting points are to narrow for large fixtures, which is a pity since the stand can handle the weigth. E.g. ADJ flat LED PARS are ok but the Quad Phase is problematic. In all a good stand for small to medium sized fixtures for the price.
0
0
Report
KA
Nice compact and lightweight, could be slightly larger horizontaly
It's a relatively compact and lightweight stand, I have used it with up to 4 LED PAR64 so I can't tell about max weight limitations, but with that much load it was fine and stable.
My main complaint is that the horizontal bar could be a bit wider because with PAR64 sized cans you are a bit limited with turning angles. It's certainly usable, but 20-30cm more in total would make a difference.
My main complaint is that the horizontal bar could be a bit wider because with PAR64 sized cans you are a bit limited with turning angles. It's certainly usable, but 20-30cm more in total would make a difference.
0
0
Report
A
Cheap and lightweight!
Perhaps not the most solid stand on the market, but it's lightweight and it folds.
I've used these for my par-cans and they do that job very well! I wouldn't try to put a lot of weight in these though... But for PARs and flower-fx etc., these are way better than a lot of similar stands!
I've used these for my par-cans and they do that job very well! I wouldn't try to put a lot of weight in these though... But for PARs and flower-fx etc., these are way better than a lot of similar stands!
0
0
Report
A
good quality for the price
i bought 2 of them and tehy are fine.i put par lights on them and they handle tah job really well.they are light and sturdy.
0
0
Report