Sütiket használunk a lehető legjobb vásárlási élmény érdekében, ami számos egyéb kényelmi funkcióval is együtt jár, így például a preferenciák megjegyzésével és testreszabott termékajánlatokkal. Ha ezzel szemben nincs fenntartásod, a "Rendicsek" gombra kattintva jóváhagyhatod a preferenciákkal kapcsolatos, statisztikai és marketing-sütik használatát (az összes megjelenítése). A jóváhagyásodat bármikor visszavonhatod a sütik beállításainál (itt).
Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.
A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
B
Good product but too high
Bipolar 20.09.2019
It would have been nearly perfect if only it wasn't slightly higher than the standard 2U height.
For that reason it didn't fit into my rack where only exactly 2U was available. Had to sell it.
The unit itself is well made and built really tough. The wire gauge used inside was more than sufficient, internal connections where made properly (screw terminals on the sockets + ring terminals on the wires if I remember correctly).
There was enough room inside to add few relays or some electronics and it was easy enough to rewire for my needs.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
M
Size issues
Michael9841 23.11.2013
The unit is well-built and works well. The main issue is that the faceplate is slightly larger than the 2U standard: it's both too high and too wide by a couple of millimeters making it difficult to fit into a rack built to the standard. The result is that it overlaps units above and/or below it, and can run into issues fitting it between the rack' slides if they are flush against the rails. In my SKB rack I was forced to mount it with washers between the faceplate and the rails in order to lift it clear of the rack's edge and make sure it was in front of the other units in the rack in order to get it to fit. It works but should not have been required since there is a standard size for faceplates.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
S
Cheap, sturdy Product
SJS 14.02.2021
Used this Power Supply in various live and studio situations. Worked as promised - useful to connect multiple devices to a single grounded source, for example.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
very usefull for every p.a. rack
Anonim 18.03.2014
Very good contstruction and the best value for money.Must be the first part of your p.a. 19 inch rack! This will give you the solution at problems caused of long and many different kind of power cables.I highly recomend it as the first thing to everyone who is starting now to find equipment for 19 inch racks.Thanks