pro snake BNC Cable 50 Ohm 10,0m

I have quality communication receiver. But antenna hight is key ellement of having strong signal. I have DIY made few cables but it losses signal.So I purchased snake BNC.And from the worst moment it works. Low loss and good mechanical characteristc,...

We have been using these with our Radio Mic Kits and never had any problems, they get quite abused by dry hires but are performing better than expected.

Shure will try to charge you four times what the cost should be, because they refuse to tell you the impedance rating of their gear, to force you to buy their own, badly over priced cables. Shure PSM 300 runs at 50 ohms impedance throughout, this fits and works perfectly, and is a quarter the price. There is also a thomann antenna connection panel that is compatible at 50 ohms too, there are also 50 ohm bcc connectors for sale here?, so you can connect many shorter cables, into one big long cable. Works great.

i use this cable for c connecting line 6 p 180 antenna to my set of line 6 microphones. .it Works much better like withought antennas....

These are the goobay brand BNC cables you read a lot of bad things about on the net. For a reason: the contacts don’t make a secure connection, signals are interrupted every time you touch the connector. I measured several about 5 ohms of series resistance on a 10m cable.

See here for more information:
https://www.elektormagazine.com/labs/goobay-50-coaxial-cables-with-like-bnc-connectors

RF impedance RF cable.
A good quality RF cable. I wouldnt go more than 10m on cable of this grade (it is quite skinny) as the loss will out weigh the gain in position

Great value UHF cable - seems to work brilliantly.

This is a good price , In Bulgaria is most expensive !